Sanyo 42LM4RTC Uživatelský manuál

Interactive Touchscreen User Guide For serial Interface For use with models: 42LM4WPTC 42LM5WPTC 42LM4RTC 42LM

10 ADJUSTING THE TOUCH SENSITIVITY LEVEL Automatic Setup When you receive your unit, the sensitivity settings will have been optimised when the uni

11 7. The moving indicator under Finger Pressure shows the strength of touchscreens signal. Nominally the Coarse Sensitivity slider is adjusted so

12 CALIBRATION 1. Select the Calib tab as shown below (Fig 5), click the 'Start Calibration' box. Fig 5 2. You will see the followin

13 SETTING THE TOUCH OUTPUT TO SUIT THE APPLICATION PROGRAM 1. Select the Output tab. Fig 7 2. Select the mouse control required for your app

14 You must now save the settings Fig 8 1. (Fig 8) Click on file. 2. Click on save to save the current settings. When the touchscreen driver

15 DIAGNOSTICS AND FREQUENTLY ASKED QUESTIONS Testing the Hardware with ‘Graph’ 1. Select the Graph tab. Fig 9 2. Run a finger around the sen

16 MONITOR MODE Fig 10 1. This section is used to check the output of the touchscreen over the whole display area represented by the white box i

17 USING EDGE ENHANCEMENT 1. To allow easy access to the sliders and buttons at the edge of the display, the cursor can be positioned nearer the

18 FAULT FINDING GUIDE The following are some possible reasons why the touch screen might not work. If they do not solve your problem or you have a

19 There are several ways to improve system performance. Optimise the Background performance against the Applications, to do this follow the simple

2

3 TABLE OF CONTENTS ABOUT THIS MANUAL ...

4 ABOUT THIS MANUAL This manual is intended as a reference guide for the Interactive Touchscreen running under Windows XP™ or Windows Vista™. This

5 INTRODUCTION This manual will explain the workings and setup of the touchscreen fitted to your display. An explanation of the monitor and its wo

6 INSTALLATION LOADING THE TOUCH DRIVER SOFTWARE ONTO PC 1. Switch on monitor Do not plug the touchscreen interface cable into your computer.

7 STARTING THE DRIVER CONTROL PROGRAM Connect the touchscreen cable to a free serial port of the. 1. If the Touchscreen control panel is not alre

8 Fig 2 EXPLANATION OF THE STATUS SECTION 1. The following explanation of the Status section assumes that the touchscreen is physically attach

9 The mouse pointer will not respond to a touch until it has been enabled in the Output section of the Control Program. Details of this will follow